![]() ![]()
The following devices should work according to the experience of Tesla drivers. The USB device should comply with the USB3 standard and have a sufficiently high writing speed capabilities. The writing speed of the USB device is too slow, and the vehicle cannot write the large amount of data to the device fast enough. Videos sometimes contain image interference It is reported on Facebook Groups that these devices worked after formatting with Rufus. #Tesla dashcam viewer not working windowsIf you have formatted a device with Windows unsuccessfully, you should still try Rufus. #Tesla dashcam viewer not working windows 10The Rufus Tool seems to format the devices differently than the Windows 10 Explorer. So in this case you should try all front USB ports of the Tesla. Sometimes it is also reported that certain devices only work on one USB port. Other users report that for them, the Dashcam only worked with a folder named “Teslacam” without a capital C. Some users report on the Internet that with the “Cluster size” setting of “4096 bytes”, they also made USB device working that did not work with another setting. In case of doubt, plug the device directly into the port to test if it works like this. A USB hub or an extension cable between the device and the USB port can also be the cause. This problem also occurs if the TeslaCam folder was not created. The device must be formatted in either FAT32 or ext4 file system. This problem occurs if the USB device is not recognized by the vehicle. Problem troubleshooting The Dashcam icon with the red dot does not appear Then create the TeslaCam folder on the newly formatted USB device. You can also name the device with an appropriate name. Simply delete the device with the disk utility, selecting the MS-DOS (FAT) setting. #Tesla dashcam viewer not working macMac users do not need to use any special tools to format the device. Last updated on: 2:19 pmįormat the USB device for the Tesla (Mac) ![]() The red dot means the Tesla is currently recording a video and storing it on the USB device. After plugging the device into the car’s USB Port, the Dashcam logo with a red dot should appear in the upper-right corner of the screen: An empty folder named TeslaCam must then be created on the device:Ĩ. After successful formatting, click on “CLOSE”.ħ. Click on “START” to delete the USB device and format it with FAT32.Ħ. For “Cluster size” select the option with the label (default).ĥ. For “File system” choose “FAT32 (default)”.Ĥ. Under “Boot Selection” select the option “Non-bootable”.ģ. Important: make sure that you have selected the correct device!Ģ.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |